All employees of the Dongguan hardware processing factory should check whether their clothing meets the job requirements before entering their posts. Slippers, high heels and clothing that may affect safety are not allowed. People with long hair must wear safety helmets. When working, maintain the correct posture and have sufficient energy to deal with the work. If you feel unwell, leave your post immediately and report it to your supervisor. When operating, one must be fully concentrated. Chatting is strictly prohibited. Cooperate with each other. Operators must not operate when they are agitated or tired to avoid accidents and ensure operational safety.

2. Before the machine starts working, check whether the moving parts have been lubricated with oil. Then start the machine and check if the clutch and brake are functioning properly. Let the machine idle for 1 to 3 minutes. Do not operate the machine if there is any malfunction.

When changing molds in Dongguan hardware processing factories, the power supply should be turned off first. Only after the movement part of the press stops running can the installation and debugging of the molds begin. After the installation and adjustment are completed, manually move the flywheel for a test punch twice to check if the upper and lower molds are symmetrical and reasonable, if the screws are tight, and if the blank holder is in a reasonable position.

4. The power must be turned on and the machinery started only after all other personnel have left the mechanical work area and removed any debris from the workbench.

V. After the machinery in the Dongguan hardware processing factory is started, only one person is allowed to transport materials and operate the machinery. Others are not permitted to press the electrical switch or step on the foot switch board. It is strictly forbidden to put hands into the working area of the machinery or touch the moving parts of the machinery with hands. When the machine is in operation, it is strictly prohibited to insert hands into the working area of the slider. It is also forbidden to take or place workpieces by hand. When taking out or placing workpieces in the die, tools that meet the standards must be used. If any abnormal sound or malfunction of the machinery is detected, the power switch should be turned off immediately for inspection. Six. When leaving work, one should turn off the power supply and tidy up the finished products, scraps and sundries on the post to ensure a clean and safe working environment.

The above operating procedures must be voluntarily followed. Do not operate in violation of regulations. In case of malfunction, cooperate with maintenance personnel for inspection and repair. In case of an accident, immediately cut off the power supply, keep the scene and report to the factory management for handling. All consequences caused by violation of operating procedures shall be borne by the person involved.